www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / Access Control Lists / Lab 056: Configuring and Applying Standard Named ACLs

Lab 056: Configuring and Applying Standard Named ACLs

Lab 56:

Configuring and Applying Standard Named ACLs

Lab Objective:

The objective of this lab exercise is for you to learn and understand how to create and apply standard named Access Control Lists.

Lab Purpose:

Configuring and applying standard ACLs is a fundamental skill. Standard ACLs filter based on source address and should be applied as close to the destination as possible. As a Cisco engineer, as well as in the Cisco CCNA exam, you will be expected to know how to create and apply standard numbered ACLs.

Certification Level:

This lab is suitable for CCNA certification exam preparation

Lab Difficulty:

This lab has a difficulty rating of 7/10

Readiness Assessment:

When you are ready for your certification exam, you should complete this lab in no more than 20 minutes

Lab Topology:

Please use the following topology to complete this lab exercise:

101labs_fig53

 

Task 1:

Configure the hostnames on routers R1 and R3 as illustrated in the topology.

Task 2:

Configure R1 S0/0 which is a DCE to provide a clock rate of 768Kbps to R3. Configure the IP addresses on the Serial interfaces of R1 and R3 as illustrated in the topology. Configure a static default route on R1 pointing to R3 over the Serial connection between the two routers. Also configure a static default route on R3 pointing to R1 via the Serial connection between the two routers. Configure the Loopback interfaces specified in the diagram on R3.

Task 3:

To test connectivity, ping R1 from R3 Serial0/0, Loopback10, Loopback20 and Loopback30 interfaces. To ping from the Loopback interfaces, use the ping <ip_address> source <interface> command.

Task 4:

On R1, create a standard named ACL to prevent inbound traffic from the Loopback10 and Loopback30 subnet on R3, but explicitly allow all inbound traffic from Serial0/0 and Loopback20 subnets on R3. This ACL should be named LOOPBACK-10-30-ACL. Apply this ACL inbound on Serial0/0. Now, try to ping R1 from R3 Serial0/0, Loopback10, Loopback20, and Loopback30 using the ping <ip_address> source <interface> command. If you have configured this correctly, only ping from Serial0/0 and Loopback20 will work.

Prev

Next

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.