Task 1:
For reference information on configuring hostnames, please refer to:
Lab 35 Configuration and Verification Task 1
Task 2:
For reference information on configuring and verifying VLANs, please refer to:
Lab 1 Configuration and Verification Task 3
Lab 2 Configuration and Verification Task 3
Task 3:
For reference information on configuring DCE clocking, please refer to:
Lab 21 Configuration and Verification Task 2
Lab 35 Configuration and Verification Task 2
For reference information on configuring Loopback interfaces, please refer to:
Lab 39 Configuration and Verification Task 4
Lab 43 Configuration and Verification Task 2
Task 4:
For reference information on using SDM to configure & verify interfaces, please refer to:
Lab 83 Configuration and Verification Task 4
Lab 83 Configuration and Verification Task 5
Task 5:
For reference information on configuring RIPv2, please refer to:
Lab 36 Configuration and Verification Task 5
Lab 37 Configuration and Verification Task 4
Task 6:
To complete this task you need to navigate to the router properties as follows:
1. On the top menu click on Configure.
2. Under Tasks, click on Routing.
3. Next, highlight RIP and click on Edit.
4. Check the Enable RIP checkbox and click on the Version 2 radio box to configure RIPv2.
5. Next click on Add and enter in the networks you want RIPv2 to advertise.
6. Repeat step 5 for the 10.1.1.0/24 subnet and click OK when complete.
R2#show ip route rip
10.0.0.0/24 is subnetted, 1 subnets
R 10.1.1.0 [120/1] via 172.16.1.1, 00:00:09, Serial0/0
R2#ping 10.1.1.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.1.1.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/4 ms