Lab 91 Solution: Using Cisco SDM to configure Port Address Translation

Task 1:

For reference information on configuring hostnames, please refer to:

Lab 35 Configuration and Verification Task 1

Task 2:

For reference information on configuring and verifying VLANs, please refer to:

Lab 1 Configuration and Verification Task 3

Lab 2 Configuration and Verification Task 3

Task 3:

For reference information on configuring DCE clocking, please refer to:

Lab 21 Configuration and Verification Task 2

Lab 35 Configuration and Verification Task 2

For reference information on configuring IP interfaces, please refer to:

Lab 31 Configuration and Verification Task 3

Lab 56 Configuration and Verification Task 2

Task 4:

For reference information on using SDM to configure & verify interfaces, please refer to:

Lab 83 Configuration and Verification Task 4

Lab 83 Configuration and Verification Task 5

Task 5:

To complete this task you need to navigate to the router properties as follows:

1. On the top menu click on Configure.

2. Under Tasks, click on NAT.

3. Next, click on the Create NAT Configuration tab.

4. Click on the Basic NAT radio box.

5. Next, Click the Launch the selected task button to launch the Wizard.

6. Click Next.

7. On the drop-down menu for the interface that connects to the Internet, select Serial0/0 and then check the box for the Ethernet0/0 subnet, which is our private IP address space. Then click Next.

8. The Summary of the Configuration page appears. Click Finish to send the configuration to the router.

Task 6:

Sw1>ping 172.16.1.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 172.16.1.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 4/6/8 ms

Sw1>telnet 172.16.1.2

Trying 172.16.1.2 … Open

User Access Verification

Password:

R2#