Task 1:
For reference information on configuring hostnames, please refer to:
Lab 35 Configuration and Verification Task 1
Task 2:
For reference information on configuring and verifying VLANs, please refer to:
Lab 1 Configuration and Verification Task 3
Lab 2 Configuration and Verification Task 3
Task 3:
To complete this task you need to navigate to the router properties as follows:
1. On the top menu click on Configure.
2. Under Tasks, click on Additional Tasks.
3. Next, expand the Router Access selection.
4. Click on VTY
5. On the right hand side, click Edit.
6. Check that the Telnet and SSH boxes under Input Protocol have a check mark against them. This is the default.
7. Under Access Rule, right-click the radio box on the same line as the Inbound access rule statement. Doing so will allow you to create an ACL that can be used to restrict Telnet and SSH access to the router.
8. Click on Create a new rule (ACL) and select…
9. Assign a name or number to your ACL, and under the Type drop-down menu, select Standard Rule. You should also add a meaningful description to the ACL you are about to create as illustrated below.
10. Under Rule Entry, click on the Add button.
11. Enter the network and wildcard mask. You can also chose to log when packets match this ACL.
12. Click OK to return to the main menu.
13. Click OK again and the commands are sent to the router.