Task 1:
For reference information on configuring hostnames, please refer to:
Lab 35 Configuration and Verification Task 1
Task 2:
For reference information on configuring DCE clocking, please refer to:
Lab 20 Configuration and Verification Task 3
Lab 21 Configuration and Verification Task 3
Lab 21 Configuration and Verification Task 2
Lab 35 Configuration and Verification Task 2
Task 3:
R3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R3(config)#line vty 0 4
R3(config-line)#login local
R3(config-line)#end
R3#
| NOTE: The login local command specifies that the device should use the local database for user authentication. When configured, you must also configure username and password pairs to be used to gain access to the device. |
Task 4:
R3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R3(config)#username admin privilege 15 password cisco
R3(config)# username test privilege 1 password cisco
R3(config)#end
R3#
R1#telnet 192.168.254.3
Trying 192.168.254.3 … Open
User Access Verification
Username: admin
Password:
R3#
R1#telnet 192.168.254.3
Trying 192.168.254.3 … Open
User Access Verification
Username: test
Password:
R3>
| NOTE: Notice how user admin is automatically in Privileged Exec mode after successful login, as illustrated by the # sign; however, we can see that user test (who has a privilege level of 1) is automatically put into User Exec mode after successful login, as illustrated by the > sign. |