Task 1:
For reference information on configuring hostnames, please refer to:
Lab 35 Configuration and Verification Task 1
Task 2:
R1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#banner motd %
Enter TEXT message. End with the character '%'.
##################################################
This is a private system. If you have connected to this device
accidentally, please disconnect immediately!
##################################################
%
R1(config)#end
R1#
NOTE: Be careful not to use the delimiting character in your banner configuration. Most people have a tendancy to use the # symbol as a delimiting character, and then forget and use it in their banner configuration . . .
The content below this message is for members only.