Task 1:
For reference information on configuring hostnames, please refer to:
Lab 35 Configuration and Verification Task 1
Task 2:
For reference information on configuring and verifying VLANs, please refer to:
Lab 1 Configuration and Verification Task 3
Lab 2 Configuration and Verification Task 3
Task 3:
For reference information on configuring IP interfaces, please refer to:
Lab 31 Configuration and Verification Task 3
Lab 56 Configuration and Verification Task 2
Task 4:
Sw1#config te
Enter configuration commands, one per line. End with CNTL/Z.
Sw1(config)#ip http server
Sw1(config)#ip http authentication local
Sw1(config)#username ADMIN privilege 15 password CISCO
Sw1(config)#end
R1#
| NOTE: Because you will be accessing the device via HTTP, ensure that you set the privilege level of the HTTP administrator to 15. This is a commonly forgotten task. Remember it. |
Task 5:
If you had access to the device via a PC in your lab, expect to see something similar to the following when you connect to it via HTTP:
You could then navigate using the browser and perform basic configurations as well as basic diagnostic testing on the device. Keep in mind that this is the HTTP access method for devices that are not supported by SDM.