www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / IP Routing Solutions / Lab 35 Solution: Configuring RIP version

Lab 35 Solution: Configuring RIP version

Task 1:

Router#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#host R1

R1(config)#

Router#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)#host R2

R2(config)#

Task 2:

R2#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

R2(config)#int s0/0

R2(config-if)#clock rate 2000000

R2(config-if)#end

R2#

R2#sh controllers s0/0

Interface Serial0/0

Hardware is PowerQUICC MPC860

DCE V.35, clock rate 2000000

R1#conf t

Enter configuration commands, one per line.  End with . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.