www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / IP Routing / Lab 053: Manually configuring the OSPF router ID

Lab 053: Manually configuring the OSPF router ID

Lab 53:

Manually configuring the OSPF router ID

Lab Objective:

The objective of this lab exercise is for you to learn and understand how to manually configure the OSPF router ID.

Lab Purpose:

Manually configuring the OSPF router ID is a fundamental skill. By default, if only physical interfaces are configured on a router, the highest IP address of those interfaces is used as the OSPF router ID. However, if both Loopback and physical interfaces are configured, then the Loopback interfaces are preferred when Cisco IOS selects the router ID for OSPF. However, the recommended method to select an OSPF . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.