www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / Local Area Networks Solutions / Lab 10 Solution: Configuring Spanning-Tree Protocol for Access ports

Lab 10 Solution: Configuring Spanning-Tree Protocol for Access ports

Task 1:

For reference information on configuring hostnames, please refer to:

Lab 1 Configuration and Verification Task 1

Lab 3 Configuration and Verification Task 1

Task 2:

For reference information on configuring verifying VLANs, please refer to:

Lab 1 Configuration and Verification Task 3

Lab 2 Configuration and Verification Task 3

Task 3:

Sw1#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Sw1(config)#interface range fastethernet0/1 - 2

Sw1(config-if-range)#switchport mode access

Sw1(config-if-range)#switchport access vlan 10

Sw1(config-if-range)#spanning-tree portfast

%Warning: portfast should only be . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.