Task 1:
For reference information on configuring hostnames, please refer to:
Lab 1 Configuration and Verification Task 1
Lab 3 Configuration and Verification Task 1
Task 2:
For reference information on configuring verifying VLANs, please refer to:
Lab 1 Configuration and Verification Task 3
Lab 2 Configuration and Verification Task 3
Task 3:
For reference information on configuring IP interfaces, please refer to:
Lab 3 Configuration and Verification Task 5
For reference information on using standard PING, please refer to:
Lab 15 Configuration and Verification Task
Task 4:
Sw1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Sw1(config)#line vty 0 15
Sw1(config-line)#password CISCO
Sw1(config-line)#login
Sw1(config-line)#end
Sw1#
| NOTE: Most people often forget the fact that switches typically have 16 VTY lines (numbered 0-15) unlike routers which typically have 5 VTY lines (numbered 0-4). Take care to remember this when configuring switches as you may leave some lines unsecured if you use line vty 0 4 as on a router. |
R1#telnet 10.0.0.2
Trying 10.0.0.2 … Open
User Access Verification
Password:
Sw1#
Sw1#