www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / Local Area Networks Solutions / Lab 19 Solution: Configuring passwords on Catalyst Switches

Lab 19 Solution: Configuring passwords on Catalyst Switches

Task 1:

Sw1#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Sw1(config)#enable password C?1sc0

Sw1(config)#end

Sw1#

NOTE: In order to use a question mark in a password on Cisco devices, you must type in CTNL/V (the CTRL key followed by the letter v) before you type in the question mark.

Task 2:

Sw1#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Sw1(config)#no service password-encryption

Sw1(config)#end

Sw1#

Sw1#show running-config

Building configuration...

Current configuration : 3093 bytes

!

version 12.1

no service . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.