www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / Local Area Networks Solutions / Lab 2 Solution: Configuring extended VLANs on Catalyst Switches

Lab 2 Solution: Configuring extended VLANs on Catalyst Switches

Task 1:

NOTE: By default, Cisco switches are VTP servers. Only standard range VLANS 1-1005 are configurable on VTP servers. To configure extended range VLANS (1006-4096) you must configure the switch as a VTP Transparent switch. Otherwise, you will get the following error message:

 

Sw1(config)#vlan 2010

Sw1(config-vlan)#end

Extended VLANs not allowed in VTP SERVER mode

Failed to commit extended VLAN(s) changes.

 

NOTE: Configuration files will be kept from previous labs. In order to remove them you can re-type the commands with the word 'no' in front.:

 

Sw1(config . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.