Task 1:
Switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#hostname Sw1
Sw1(config)#
Switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#hostname Sw2
Sw1(config)#
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R1
R1(config)#
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R3
R3(config)#
Task 2:
NOTE: By default, Cisco switches are VTP servers so no configuration is necessary for Server mode on Sw1. This can . . .
The content below this message is for members only.