Lab 3:
Configuring VTP Clients and Servers on Catalyst Switches
Lab Objective:
The objective of this lab exercise is for you to learn and understand how to configure VTP Server and Client mode on Cisco Catalyst switches. By default, all Cisco switches are VTP Server devices.
Lab Purpose:
VTP Client and Server mode configuration is a fundamental skill. VLANs are configured on VTP Servers and VTP Clients receive VLAN information from the VTP Servers in the same VTP domain. VLAN sharing is possible by using a trunk between the switches. As a Cisco engineer, as well as in the Cisco CCNA exam, you will be expected to know how to configure VTP Client and Server mode.
Certification Level:
This lab is suitable for both CCENT and CCNA certification exam preparation
Lab Difficulty:
This lab has a difficulty rating of 5/10
Readiness Assessment:
When you are ready for your certification exam, you should complete this lab in no more than 15 minutes
Lab Topology:
Please use the following topology to complete this lab exercise:
Task 1:
In preparation for VLAN configuration, configure a hostname on Sw1 as well as the VLANs depicted in the topology. Keep in mind that the default mode of operation of Cisco Catalyst switches is VTP Server mode.
Task 2:
Configure and verify Sw1 as a VTP Server switch and configure Sw2 as a VTP Client switch. Both switches should be in the VTP domain named CISCO.
Task 3:
Configure and verify FastEthernet0/1 between Sw1 and Sw2 as an 802.1q trunk
Task 4:
Configure and verify VLANs 10 and 20 on Sw1 with the names provided above. Assign FastEthernet0/2 on both Sw1 and Sw2 to VLAN 10. This interface should be configured as an access port.
Task 5:
Configure R1 and R3 FastEthernet0/0 interfaces with the IP addresses 10.0.0.1/28 and 10.0.0.3/28 respectively. Test connectivity via your VLANs by pinging R1 from R3 and vice versa.