www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / 101 CCNA LABS / Network Address Translation Solutions / Lab 65 Solution: Configuring Static Network Address Translation

Lab 65 Solution: Configuring Static Network Address Translation

Task 1:

For reference information on configuring hostnames, please refer to:

Lab 35 Configuration and Verification Task 1

Task 2:

For reference information on configuring DCE clocking, please refer to:

Lab 57 Configuration and Verification Task 2

Lab 58 Configuration and Verification Task 2

For reference information on configuring IP interfaces, please refer to:

Lab 31 Configuration and Verification Task 3

Task 3:

Sw1#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Sw1(config)#vlan 50

Sw1(config-vlan)#name NAT_VLAN

Sw1(config-vlan)#exit

Sw1(config)#int f0/2

Sw1(config-if)#switchport mode access . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.