Task 1:
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R1
R1(config)#
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#hostname R2
R2(config)#
Task 2:
R1(config)#interface serial0/0
R1(config-if)#no shut
*Mar 1 00:36:47.282: %LINK-3-UPDOWN: Interface Serial0/0, changed state to down
R1(config-if)#end
R1#
R2(config)#interface serial0/0
R2(config-if)#no shut
*Mar 1 00:36:47.282: %LINK-3-UPDOWN: Interface Serial0/0, changed state to down
R2(config-if)#end
R2#
R2#show controllers serial 0/0
Interface Serial0/0
Hardware is PowerQUICC MPC860
DCE V.35, no clock
| NOTE: The show controllers command will tell you whether the interface is the DCE side (which provides the clocking) or the DTE side (which receives the clocking) on a particular router interface. |
Task 3:
R2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R2(config)#interface serial 0/0
R2(config-if)#clock rate 256000
R2(config-if)#end
R2#
R2#show controllers serial 0/0
Interface Serial0/0
Hardware is PowerQUICC MPC860
DCE V.35, clock rate 256000
R1#show controllers serial 0/2
Interface Serial0/0
Hardware is PowerQUICC MPC860
DTE V.35 TX and RX clocks detected.
Task 4:
R1#conf term
Enter configuration commands, one per line. End with CNTL/Z.
R1(config)#interface s0/0
R1(config-if)#ip address 172.30.100.1 255.255.255.252
R1(config-if)#end
R1#
R2#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R2(config)#interface serial 0/0
R2(config-if)#ip address 172.30.100.2 255.255.255.252
R2(config-if)#end
R2#
Task 5:
R1#show ip interface brief
Interface IP-Address OK? Method Status Protocol
Serial0/0 172.30.100.1 YES manual up up
R1#ping 172.30.100.2
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.30.100.2, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/12 ms
R2#show ip interface brief
Interface IP-Address OK? Method Status Protocol
Serial0/0 172.30.100.2 YES manual up up
R2#ping 172.30.100.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.30.100.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/12 ms