CCNP Lab 016: EIGRP Multi-Technology Lab

IMPORTANT NOTE

If you are using the www.howtonetwork.net racks, please bring up the LAN interfaces connected to the routers by issuing the no shutdown command on the connected switches. If you are using a home lab with no
Switches, you can bring up the LAN interfaces using the following configurations on your routers:

interface fastethernet 0/0
 no keepalive
 loopback
 no shutdown

Alternately, you can simply connect the interfaces to a hub or switch if you have one available in your own lab. Also, if you are using the www.howtonetwork.net racks, configure R3 as the Frame Relay switch using the following configuration commands:

hostname R3-Frame-Relay-Switch
!
frame-relay switching
!
interface serial 1/0
 description ‘Connected To R1 Serial 0/1’
 encapsulation frame-relay
 no ip address
 clock rate 128000
 frame-relay intf-type dce
 frame-relay route 102 interface serial 1/1 201
 frame-relay route 104 interface serial 1/2 401
 no shutdown
!
interface serial 1/1
 description ‘Connected To R2 Serial 0/1’
 encapsulation frame-relay
 no ip address
 clock rate 128000
 frame-relay intf-type dce
 frame-relay route 201 interface serial 1/0 102
 no shutdown
!
interface serial 1/2
 description ‘Connected To R4 Serial 0/0’
 encapsulation frame-relay
 no ip address
 clock rate 128000
 frame-relay intf-type dce
 frame-relay route 401 interface serial 1/0 104
 no shutdown
!
end