Lab Objective:
The focus of this lab is to understand tunneling implementation and configuration in Cisco IOS routers. Additional technologies include Multi Protocol Border Gateway Protocol (MP-BGP).
Lab Topology:
The lab network topology is illustrated below:
|
IMPORTANT NOTE If you are using the www.howtonetwork.net racks, please bring up the LAN interfaces connected to the routers by issuing the no shutdown command on the connected switches. If you are using a home lab with no interface fastethernet 0/0 Alternately, you can simply connect the interfaces to a hub or switch if you have one available in your own lab. |
Task 1
Configure hostnames, IP addressing on all routers as illustrated in the network topology.Â
Task 2
Enable EIGRP on all routers as illustrated in the topology. Verify your EIGRP configuration.
Task 3
Configure automatic IPv4-compatible tunnels on R1 and R4. The tunnel source interface should be configured as the WAN interface. Verify the configuration using the appropriate commands.
Task 4
Enable MP-BGP between R1 and R4 using AS 254 and advertise the LAN subnets connected to R1 and R4. Use the WAN interface addresses to complete the 128-bit IPv6 addresses that will be used for peering. Verify that you can ping LAN-to-LAN between R1 and R4.