1. Which of the following tools can measure open and short circuits?
a. Punch-down tool
b. Crimper
c. Cable tester
d. Butt set
e. Loopback plug
2. Which of the following tools is used to install connectors on the cable?
a. Punch-down tool
b. Crimper
c. Cable tester
d. Butt set
e. Loopback plug
3. Which of the following tools is used to measure the distance of an optical cable?
a. Punch-down tool
b. Crimper
c. TDR
d. Butt set
e. Loopback plug
f. OTDR
4. Which of the following tools is used to tap into a telephone circuit and listen to the line?
a. Punch-down tool
b. Crimper
c. TDR
d. Butt set
e. Loopback plug
f. OTDR
5. Which of the following tools uses a tone generator to send a signal on the wire?
a. Punch-down tool
b. Crimper
c. TDR
d. Butt set
e. Toner probe
f. OTDR
6. Which of the following tools is used on a wiring block to insert wires into punch-down blocks?
a. Punch-down tool
b. Crimper
c. TDR
d. Butt set
e. Toner probe
f. OTDR
7. Which of the following techniques can be used to capture traffic in order to direct it to a protocol analyzer?
a. Routing process
b. ARP
c. Port mirroring
d. LACP
e. CDP
8. Loopback plugs function by sending data out of a connection and then looping it right back in (true or false).
a. True
b. False
9. Which of the following parameters can be measured by a multimeter?
a. Voltage
b. Current
c. Resistance
d. All of the above
10. Which of the following tools is the most expensive?
a. Copper crimper
b. Loopback plug
c. OTDR