Use two directly connected routers and test the basic commands depicted in this module. RIP is no longer in the CCNA exam but it’s a very easy protocol to use for a simple lab.
- Assign an IPv4 address to the directy connected interfaces (10.10.10.1/24 and 10.10.10.2/24)
- Test direct connectivity using ping
- Configure a Loopback interface on each router and assign addresses from two different ranges (11.11.11.1/32 and 12.12.12.2/32)
- Configure standard RIP and advertise all the local networks
R1:
router rip
version 2
no auto
network 10.10.10.0
network 11.11.11.0
R2:
router rip
version 2
no auto
network 10.10.10.0
network 12.12.12.0
- Ping R2 Loopback from R1 to test connectivity
- Issue a show ip route command to verify that routes are being received via RIP
- Issue a show ip protocols command to verify that RIP is configured and active on the devices
Visit www.in60days.com and watch me do this lab for free.