Use two directly connected routers and test the basic commands depicted in this module. RIP is no longer in the CCNA exam but it’s a very easy protocol to use for a simple lab.
- Assign an IPv4 address to the directy connected interfaces (10.10.10.1/24 and 10.10.10.2/24)
- Test direct connectivity using ping
- Configure a Loopback interface on each router and assign addresses from two different ranges (220.127.116.11/32 and 18.104.22.168/32)
- Configure standard RIP and advertise all the . . .
The content below this message is for members only.