Repeat the scenario from Day 12 (two routers directly connected, Loopback interface on each of them) but instead of configuring OSPF for IPv4, configure IPv6 addresses and advertise them using OSPFv3 between the devices:
- Assign an IPv6 address to the directly connected interfaces (2001:100::1/64 and 2001:100::2/64)
- Test direct connectivity using ping
- Configure a Loopback interface on each router and assign addresses from two different ranges (2002::1/128 and 2002::2/128)
- Configure standard OSPFv3 process 1 and advertise all the local networks in Area 0. Also, configure a router id for each device
R1:
ipv6 router ospf 1
router-id 1.1.1.1
int fa0/0 (or the specific interface number)
ipv6 ospf 1 area 0
int lo0 (or the specific interface number)
ipv6 ospf 1 area 0
R2:
ipv6 router ospf 1
router-id 2.2.2.2
int fa0/0 (or the specific interface number)
ipv6 ospf 1 area 0
int lo0 (or the specific interface number)
ipv6 ospf 1 area 0
- Ping R2 IPv6 Loopback from R1 to test connectivity
- Issue a show ipv6 route command to verify that routes are being received via OSPFv3
- Issue a show ipv6 protocols command to verify that OSPFv3 is configured and active on the devices
- Verify the interface OSPF-specific parameters: show ipv6 ospf interface and show ipv6 ospf interface brief
- Change the OSPF Hello and Dead timers on both routers (directly connected interfaces): ipv6 ospf hello and ipv6 ospf dead
- Issue a show ipv6 ospf 1 command to see the routing process parameters
Visit www.in60days.com and watch me do this lab for free.