www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND1 / Day 13 – OSPFv3 / Day 13 Tasks / Configuring and Verifying OSPFv3 in Cisco IOS Software

Configuring and Verifying OSPFv3 in Cisco IOS Software

Continuing from the previous section, which highlighted the configuration differences between OSPFv2 and OSPFv3, this section goes through the steps required to enable and verify OSPFv3 functionality and routing in Cisco IOS software. The following sequence of steps should be taken to enable OSPFv3 routing in Cisco IOS software:

  1. Globally enable IPv6 routing using the ipv6 unicast-routing global configuration command. By default, IPv6 routing is disabled in Cisco IOS software.
  2. Configure one or more OSPFv3 processes using the ipv6 router ospf [process ID] global configuration command.
  3. If there are no operational interfaces with . . .

    The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.