Repeat the previous lab. This time, when referring to the pool, add the overload command to the end of the configuration line. This instructs the router to use PAT. Leave off Loopback1. Please note that as Farai says, in the real world, your pool will usually have only one address or you will overload your outside interface.
RouterA(config)#ip nat inside source list 1 pool 60days overload
I’ve done some of the previous labs using Cisco Packet Tracer for convenience, so you will often see different output to mine. Here is a sample output from a PAT lab . . .
The content below this message is for members only.