www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND2 / Day 38 – EIGRP For IPv6 / Day 38 Tasks / Configuring and Verifying EIGRPv6 in Cisco IOS Software

Configuring and Verifying EIGRPv6 in Cisco IOS Software

Continuing from the previous section, which highlighted the configuration differences between EIGRPv4 and EIGRPv6, this section goes through the sequence of steps required to enable and verify EIGRPv6 functionality and routing in Cisco IOS software, as follows:

  1. Globally enable IPv6 routing using the ipv6 unicast-routing global configuration command. By default, IPv6 routing is disabled in Cisco IOS software.
  2. Configure one or more EIGRPv6 processes using the ipv6 router eigrp [ASN] global configuration command.
  3. If there are no operational interfaces with an IPv4 address configured on the router, then configure the EIGRPv6 . . .

    The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.