www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND2 / Day 42 – Frame Relay and PPP / Day 42 Labs / Point-to-Point Protocol Lab

Point-to-Point Protocol Lab

Topology

 

Purpose
Learn how to configure PPP and CHAP.

 
Walkthrough

  1. Configure IP addresses and hostnames as per the topology above.
  2. Set the encapsulation on each side to PPP. Here is the command for Router A:

RouterA(config)#interface s0/1/0

RouterA(config-if)#encapsulation ppp

  1. Set CHAP on each router. You will set the hostname of the opposite router and the password cisco.

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.