www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND2 / Day 42 – Frame Relay and PPP / Day 42 Tasks / Configuring Frame Relay

Configuring Frame Relay

Unfortunately, it can be somewhat tricky to configure Frame Relay, and this is because different network types require different commands. The reason for this is to overcome how network addresses resolve over the WAN and how routing protocols operate. The steps to configure Frame Relay are as follows:

  1. Set encapsulation
  2. Set LMI type (optional)
  3. Configure static/dynamic address mapping
  4. Address protocol-specific problems

You will not be expected to know how to configure a telco Frame Relay switch in the CCNA exam. You would only want to know how to . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.