www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND2 / Day 47 – Review 5 / Day 47 Lab – EIGRP and ACL

Day 47 Lab – EIGRP and ACL

Topology

 Day 47 Lab – EIGRP and ACL

 Instructions

Connect two routers together with a serial or crossover cable:

  1. Add IP addresses to the routers and a Loopback interface on Router A and Router B, according to the diagram
  2. Ping between Router A and Router B to test the serial line (remember clock rates)
  3. Configure EIGRP 30 on both routers
  4. Add all routes and add wildcard masks
  5. Check the routing table. Were the routes summarised?
  6. Now add the no auto-summary command to the EIGRP process
  7. Ping all routes
  8. Now add a named ACL on Router B; only Telnetting to 10.2.2.2 should be permitted
  9. Make sure you have enabled Telnet and have added a username/password
  10. Test the ACL by attempting to connect to 172.16.1.6 first, and then to 10.2.2.2
  11. If EIGRP is no longer working, why would that be and how do you fix the issue?

 

Solution Hints and Commands

  • router eigrp 30

network 0.0.0.0 255.255.255.255

  • show ip route to check the routing table
  • ip access-list to add a named ACL
  • username x password y

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.