www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / ICND2 / Day 53 – Review 11 / Day 53 Lab – EIGRP and ACL

Day 53 Lab – EIGRP and ACL

Topology

 Day 53 Lab – EIGRP and ACL

Instructions

Connect three routers together with a serial or crossover cable:

  1. Add IP addresses to the routers and Loopback interfaces on Routers A, B, and C, according to the diagram
  2. Ping between Routers A and B and between Routers B and C to test the serial lines (remember clock rates)
  3. Now set the serial lines to use PPP with CHAP (also set usernames and passwords)
  4. Configure EIGRP 40 on all routers
  5. Check the routing tables and make sure that you include both of the 192.168.1.x networks
  6. Set an ACL to Router A; Telnet should be permitted from the Router C Serial address, but not from Router B; permit Telnet on Router A first, of course

Solution Hints and Commands

  • router eigrp 40
  • Use the network command to advertise the network in EIGRP
  • Use the access-class command on VTY lines to filter traffic
  • NOTE: The two networks on Router B are 192.168.1.12/30 and 192.168.1.16/30

 

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.