Topology
Instructions
Connect three routers together with a serial or crossover cable:
- Add IP addresses to the routers and Loopback interfaces on Routers A, B, and C, according to the diagram
- Ping between Routers A and B and between Routers B and C to test the serial lines (remember clock rates)
- Now set the serial lines to use PPP with CHAP (also set usernames and passwords)
- Configure OSPF on all routers; put one Loopback on either end in a non-zero area, but do not add 172.30.1.0 to OSPF
- Check the routing tables and make sure that you include both of the 192.168.1.x networks
- Create a NAT pool of 192.168.2.1 to 10/24, inclusive, on Router A; set an ACL to match the 172.30.1.0/28 subnet
- Set a static route on Router B for traffic destined to 192.168.2.0/24 to next-hop 192.168.1.13
- Turn on NAT debugging on Router A, and do an extended ping from 172.30.1.1 to Router B
Solution Hints and Commands
- Use the ip address on interface command to set an IP address
- CHAP: username and password for remote peer, ppp authentication chap on interfaces
- Use the router ospf x command to enter Router Configuration mode
- Define networks under the router ospf command with a network statement
- Use the ip access-list command for named ACLs
- Use the ip route command for static route configuration
- debug ip nat
NOTE: The two networks on Router B are 192.168.1.12/30 and 192.168.1.16/30
