Module 10 – Exam

1. Click on the Exhibit.

What routing protocol would be used between R1 and R2 to provide Loopback-to-Loopback connectivity allowing for the two BGP speakers to establish an adjacency using their Loopback interfaces? Select the BEST answer.

2. Click on the Exhibit.

RZ receives an UPDATE for the 150.254.0.0/24 prefix from AS 1 and AS 2.Within AS 5 routers R1 and R2 are redistributing this prefix into BGP from OSPF. However, R3 is injecting this prefix using the network command. Given this, what attribute will RZ use to select the best path to this network? Select the BEST answer.

3. Click on the Exhibit.

What can be determined from this output? Select TWO answers.

4. Click on the Exhibit.

What can be determined from this output? Select the BEST answer.

5. Which of the following is an unspecified IPv6 address? Select the BEST answer.

6. A local BGP speaker which is also receiving the 10.1.1.0/24 network via an IGP is configured to advertise the same network as follows:

router bgp 1 network 10.0.0.0

Given this configuration, which of the following statements is TRUE? Select the BEST answer.

7. Click on the Exhibit.

What can be determined from this output? Select THREE answers.

8. A BGP speaker is configured for route summarization or aggregation as follows:

router bgp 1 aggregate-address 10.0.0.0 255.0.0.0

Following this, the show ip bgp command is issued but is empty. What could the cause be? Select the BEST answer.

9. Which of the following DSL variants uses ISDN-based technology to provide a data communication channel across existing copper telephone lines at a rate of 1.44 Kbps? Select the BEST answer.

10. Which of the following is NOT included in the Virtual Link Hello and DBD packets? Select the BEST answer.

11. Which of the following illustrates how to correctly specify an area as a stub area when running OSPFv3? Select the BEST answer.

12. Which of the following statements about BGP dampening are TRUE? Select THREE answers.

13. Click on the Exhibit.

What additional configuration is required to resolve this issue? Select the BEST answer.

14. Click on the Exhibit.

Which of the following situations may result in this output? Select the BEST answer.

15. Which of the following is NOT a valid ATM Adaptation Layer (AAL) specification? Select the BEST answer.

16. Click on the Exhibit.

What can be determined from this output? Select TWO answers.

17. Which of the following describes two different methods for carrying connectionless network interconnect traffic over an ATM network, which are routed protocol data units (PDUs) and bridged PDUs? Select the BEST answer.

18. By default, OSPF re-floods all LSAs every 30 seconds

19. What MTU value must be specified when implementing PPPoE? Select the BEST answer.

20. Click on the Exhibit.

RZ receives an UPDATE for the 150.254.0.0/24 prefix from AS 1 and AS 2.Within AS 5 all routers are injecting this prefix into BGP using the network command. Given this, what attribute will RZ use to select the best path to this network? Select the BEST answer.

21. Router Advertisement messages used for IPv6 stateless Autoconfiguration include the several parameters. Which of the following is NOT a valid parameter? Select the BEST answer.