The Spanning Tree Protocol (STP) is used in switched networks to prevent loops that may be caused by having multiple redundant paths between source and destination stations. This chapter focuses on the theoretical aspects as well as the configuration of basic and advanced STP within the switched LAN. The following core SWITCH exam objective will be covered in this chapter:
- Implement VLAN-based solution, given a network design and a set of requirements
This chapter will be divided into the following sections:
- An Introduction to the Spanning Tree Protocol
- Spanning Tree Bridge Protocol Data Units
- Spanning Tree Port States
- Understanding the Spanning Tree Bridge ID
- IEEE 802.1t and the Extended System ID
- Spanning Tree Root Bridge Election
- Understanding Spanning Tree Cost and Priority
- Spanning Tree Root and Designated Ports
- Spanning Tree Timers
- Understanding the Spanning Tree Diameter
- Cisco Spanning Tree Enhancements
- Unidirectional Link Detection (UDLD)
- Configuring Spanning Tree Protocol
- Troubleshooting Spanning Tree Networks
- Summary
|
SWITCH Exam Objective |
Chapter Section(s) Covered |
|---|---|
| Configure loop prevention for the VLAN-based solution |
|