www.howtonetwork.org

CCNA & CCNP Certifcation Training

  • About
  • Contact
  • FAQ
  • Join
  • Home
  • CCNA
    • ICND1
    • ICND2
    • 101 CCNA LABS
  • CCNP
    • ROUTE
    • SWITCH
    • TSHOOT
    • 101 CCNP LABS
  • CompTIA
    • Security+
    • Network+
  • Design
    • CCDA
    • CCDP
You are here: Home / SWITCH / Module 4 / Advanced STP – Configuring Rapid Spanning Tree Protocol

Advanced STP – Configuring Rapid Spanning Tree Protocol

The only configuration command required to enable RSTP is the spanning-tree mode rapid-pvst global configuration command as illustrated in the following output:

VTP-Server-2#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
VTP-Server-2(config)#spanning-tree mode rapid-pvst
VTP-Server-2(config)#exit

Once enabled, R-PVST+ configuration can be validated via the show spanning-tree summary command, the output of which is shown below :

VTP-Server-2#show spanning-tree summary
Switch is in rapid-pvst . . .

The content below this message is for members only.

About Us

This is a free bonus site for members of www.howtonetwork.com

Copyright

The content on this copyright Reality Press Ltd.
Copyright Reality Press Ltd.