The following section lists and describes the steps that are required to configure Layer 2 PAgP EtherChannels. However, before we delve into these configuration steps, it is important that you are familiar with the following caveats when configuring Layer 2 EtherChannels:
- Each EtherChannel can have up to eight compatibly configured Ethernet interfaces. LACP allows you to have more than eight ports in an EtherChannel group. These additional ports are hot-standby ports. This was described in the previous section.
- All interfaces in the EtherChannel must operate at the same speed and duplex modes. Keep . . .
The content below this message is for members only.